ContentsIndex
Structs, Records, Enums Enumerations
Structs, Records, Enums
Enumerations
Enumeration 
Description 
Commands for serial port hardware. DCB stands for Device Control Block. Call vm_dcl_control with VM_DCL_SIO_COMMAND_SET_DCB_CONFIG to config uart driver. 
Device identifiers for serial ports. Pass this to vm_dcl_open to select one of the serial port devices to use. Currently, only the hardware UART port (TX/RX pins) is available on 2502A. The USB COM ports are used by SDK for debugging and SDK functions, therefore not available to the application. 
VM_DCL_SIO_EVENT are serial port hardware events that can be registered with vm_dcl_registercallback. 
VM_DCL_SIO_UART_BAUDRATE defines values for the baud_rate field in the serial port configuration structure vm_dcl_sio_config_t
Defines values for the data_bits_per_char_length field in vm_dcl_sio_config_t. This configures the length of data bits during UART transmission. 
Defines values for the flow_control field in vm_dcl_sio_config_t. This configures hardware or software flow control is used during UART transmission. 
Defines values for the parity field in vm_dcl_sio_config_t. This configures the behavior of parity bit during UART transmission. 
Defines values for the stop_bits field in vm_dcl_sio_config_t. This configures the stop bits during UART transmission. 
The USB cable status. 
Created with a commercial version of Doc-O-Matic. In order to make this message disappear you need to register this software. If you have problems registering this software please contact us at support@toolsfactory.com.